Skip to main content

CHEBYSHEV FILTER DESIGN

The aim of this experiment was designing analog and digital Chebyshev Filter .
 In this experiment we designed a digital Chebyshev filter from analog Chebyshev filter using BLT.
The input specifications were given as
(1) Pass band Attenuation (Ap)
 (2) Stop band Attenuation (As )
(3) Pass band Frequency (Fp) in Hz
(4) Stop band Frequency (Fs) in Hz
(5) Sampling Frequency in Hz
In the end we concluded that in both low pass and high pass filters, poles are inside the unit circle and hence they are stable. For low pass filter there is a definite zero at z=-1 while for high pass filter there is a definite zero at z=1. The values of Ap and As as input are approximately same.

Comments

  1. Chaitanya SApril 26, 2017 at 1:09 AM

    Are there ripples in chebyshev filter?

    ReplyDelete
  2. UnknownApril 26, 2017 at 1:26 AM

    Good!!

    ReplyDelete
  3. UnknownMay 1, 2017 at 8:21 PM

    In chebyshev, both low pass and high pass filters, poles are inside the unit circle

    ReplyDelete

Post a Comment

Popular posts from this blog

FAST FOURIER TRANSFORM

The aim of this experiment was to perform Fast Fourier Transform. In this experiment, we developed a program to perform FFT of N point signal. For this we gave input specifications as length of signal N and signal values.  After performing this experiment we concluded that from perspective of arithmetic computations, the number of arithmetic calculations in FFT are less than DFT.  Therefore, FFT is preferred over DFT.
4 comments
Read more

DSP PROCESSOR: HARDWARE IMPLEMENTATION

The aim of this experiment was to perform operations using DSP Processor.  We learned programming using DSP Hardware. In this experiment, we took two, 4 point signal values performed addition, subtraction, multiplication and division using Processor. We also performed bitwise logical operations and shifting of signal values. After performing each of these operations we verified the register values and compared them with the values of these registers before the execution of these instructions. We observed the practical implementation of the processor and its instructions. 
5 comments
Read more

CONVOLUTION AND CORELATION

The aim of this experiment was to study mathematical operation such as Linear convolution, Circular convolution, Linear convolution using circular convolution.We developed a function to find Linear Convolution and Circular Convolution We then concluded on aliasing effect in Circular convolution. The aim of the second part of the experiment was to study mathematical operation of correlation and measure degree of similarity between two signals. We wrote a function to find correlation operation.                                                                               We calculated correlation of a DT signals and verify the results using mathematical formulae.
2 comments
Read more