Skip to main content

IEEE Paper review on Architecture of Dual mode audio filter for AC-3 And MPEG

This blog presents normal discussion about the architecture of dual mode audio reconstruction filter which can be used for AC-3 and MPEG.It utilises the real FFT (Fast Fourier Transform), the efficient MPEG windowing. The digital audio which is an integral part of any video or multimedia application substantiates the need for an efficient compression algorithm due to its considerable consumption of the overall bandwidth. The MPEG audio coding algorithm is the first international standard for the compression of audio signals. Both MPEG and AC-3 make no assumptions about the source of the input signal, and they can be applied to both speech and high fidelity audio.

Link: http://ieeexplore.ieee.org/document/628679/

Comments

Post a Comment

Popular posts from this blog

DSP PROCESSOR: HARDWARE IMPLEMENTATION

The aim of this experiment was to perform operations using DSP Processor.  We learned programming using DSP Hardware. In this experiment, we took two, 4 point signal values performed addition, subtraction, multiplication and division using Processor. We also performed bitwise logical operations and shifting of signal values. After performing each of these operations we verified the register values and compared them with the values of these registers before the execution of these instructions. We observed the practical implementation of the processor and its instructions. 
5 comments
Read more

DESIGN OF BUTTERWORTH FILTER

The aim of this experiment was designing analog and digital Butterworth filter. We designed a digital filter from analog filter and studied the aliasing effect due to sampling in Impulse Invariant Method and the frequency warping effect in BLT Method. The Input Specifications were given as (1) Pass band Attenuation  (2) Stop band Attenuation  (3) Pass band Frequency (4) Stop band Frequency  (5) Sampling Frequency        We arrived at a conclusion that for both low pass and high pass filter, poles lie inside the unit circle. Hence both the filters are stable. But we also observed in the result that the values of Ap and As are not approximately same. Hence for better stability the order of the filter needs to be increased.
2 comments
Read more

FIR FILTER DESIGN USING FREQUENCY SAMPLING METHOD

The aim was FIR Filter design using Frequency Sampling Method. We designed the digital filter using frequency sampling method. The input specifications were given as For LPF / HPF filter Design : (1) Pass band Attenuation (Ap) (2) Stop band Attenuation (As ) (3) Pass band Frequency (Fp) in Hz (4) Stop band Frequency (Fs) in Hz (5) Sampling Frequency in Hz  For BPF / BSF filter Design : (1) Pass band Attenuation (Ap) (2) Stop band Attenuation (As ) (3) Pass band Frequency (Fp1, Fp2) in Hz (4) Stop band Frequency (Fs) in Hz (5) Sampling Frequency in Hz        In this experiment we observed that phase response will be same for low pass and high pass filter if the orders are kept same. We also verified the values of Ap and As.
2 comments
Read more